What should I pay attention to when using a single screw extruder?

single screw extruderAlthough it has many advantages, you should know that there are many things to pay attention to when operating, because most people are not very clear, so the following editor will introduce what we need to pay attention to when using it. If you also want to know, then come and have a look, hoping to help you.

single screw extruderIt is also a large-scale equipment, which brings many benefits to the enterprise when in use. Because its price is more expensive, so you don't understand do not operate, the staff to do before use is to check whether there is water, oil into the electrical control box, if the electrical damp, do not boot. It is suggested here that you should also blow dry the electrical parts by maintenance personnel before starting the machine. Then check whether the electric voltage of the single screw extruder is in line with the general should not be greater than ± 15 percent. Regarding its emergency stop switch, the front and rear safety door switches are also to be checked. In addition, when using the single screw extruder, it is also necessary to pay attention to check whether the base of the unit is fully padded and whether the anchor bolts are fastened. And you also need to fill the oil tank with the specified brand of mechanical oil to the oil level line. Its lubricating oil brand is R320 medium-load working gear oil. And the equipment must also be consistent with the direction of rotation of the oil pump. Check whether each cooling pipe is unblocked, and supply cooling water to the oil cooler and the cooling water jacket at the end of the barrel. Therefore, what is said here is also some issues that must be paid attention to in the later period.

in operationsingle screw extruderAt the same time, we also need to pay attention to whether there is lubricating oil (grease) in each active part of it, and add enough lubricating oil. When the electric heating is turned on, heat each section of the barrel. In addition, the staff should know that when the temperature of each section meets the requirements, it will hold for a period of time to stabilize the temperature of the machine. Holding time according to different equipment and gold. These are all things to do before using the single screw extruder, and they are also some places that need to be checked. If you find any problems, you should stop using them immediately. What should be known is that the staff should pay attention to when using itsingle screw extruderDo not covet convenience, arbitrarily cancel the role of the security door. Also need to pay attention to observe the temperature of the pressure oil, of course, its oil temperature should not be greater than the specified range. As long as there are no problems in these places, they can be used for a longer time. The ideal working temperature of its hydraulic oil should be maintained between 45~50 ℃, generally in the range of 35~60 ℃. Pay attention to adjust the travel limit switch, the purpose of this is to avoid the impact of the machine in the action.

To sum up, you will findsingle screw extruderThere are still a lot of things to pay attention to when using it. After all, it is a large-scale equipment. If you want to check and pay attention to every place. As long as this is done, it can be used for a longer period of time. As a professional manufacturer, we welcome you to call here to consult related issues.